***All Prices Subject To Change At Any Time Without Notice!***
Slip-resistant TITAN brand grey composite decking looks great and is textured to keep grip maximum grip even when covered in slippery lake gunk, simply scrub with a stiff-bristle brush (like a shower brush) or power wash periodically. Perfect for entry off the side of the dock into knee or waist deep water for kids, dogs and adults!
The front legs are independently adjustable to level out the steps to the lake bed, the railing side leg is hidden inside the hand rail tubing. The steps simply hang on the corner lip of your dock or steel seawall cap and bolts right through with 2-4 bolts (which you'll drill based on your particular setup) and a quick 2 set bolts to adjust the legs, for easy installation and removal at the end of the season. Welded hand-rail down the right side when walking up the steps for safety and comfort. These will not work with docks where the decking sticks out past the stringer rails on the side of the dock (primarily wooden docks), the top and side rail must come flush to a corner angle to mount them securely.
Simply measure from the top of your dock surface straight down to the lake bed in your desired mounting location, then factor in any muck if you sink past your toes to accomodate the sinking if you are not on pure sand. Sizing is listed with each size/ price, below. It is always best to have the legs retracted than to be fully extended, so if you are on the edge between two sizes, it is best to go to the next size up.
SHIPPING: WE DO NOT OFFER SHIPPING! Requires truck or trailer for pick up!
We're sorry, due to the outrageous cost of shipping something of this size, we DO NOT offer shipping. These come fully welded/ assembled for extra strength and ready to install- due to this, they require a truck (without hard tonneau cover) or a trailer for pickup, they will not fit in even the largest of SUVs due to the handrail.
2 Step (Non-Stock) - (19"-25" Height) 3' Wide Grey Composite Tread - $467.00 plus tax
3 Step- (26"-32" Height) 3' Wide Grey Composite Tread - $513.00 plus tax
4 Step (Most Common)- (33"-39" Height) 3' Wide Grey Composite Tread - $595.00 plus tax
5 Step- (40"-46" Height) 3' Wide Grey Composite Tread - $759.00 plus tax
6 Step- (47"-53" Height) 3' Wide Grey Composite Tread - $921.00 plus tax
7 Step- (54"-61" Height) 3' Wide Grey Composite Tread - $1,059.00 plus tax
SUPERIOR Universal Boat Guides &
Boat Lift Step-Over
SUPERIOR (Mostly) Universal Boat Guides & Boat Lift Step
Our 12 ft. HORIZONTAL GUIDE-ONS come with U-bolt brackets that fit either a 2"x5" or 2"x6" cradle beam size on your existing boat lift, with slider tabs that bolt to the upright tubes, allowing you to adjust the position of the uprights based on your lift. Some lift brand designs do not allow for bolting on the side cradle due to interference with the winch box when the lift is cranked up, or possibly other features of the lift- this may require you to bolt them on the side to side portion of the cradle, which will make your opening for parking narrower and tougher to get the boat started, but safer once the boat is partially inside the lift. These are best for pontoons or aluminum boats, they will almost certainly damage the gel-coat on V-hull boats if you hit them, but the trade off is that the damage should be far less than what would happen if you hit the lift frame or poke through the side of the lift and hit the dock poles with no guides at all- vertical pole guides are safer for V-hull boats, but generally only protect the four corners of the lift and not down the full length if your boat gets crooked while halfway in.
Our BOAT LIFT STEP comes with the same U-bolt brackets that the side guides come with, and have two hole options which allow it to fit either a 2"x5" or a 2"x6" side cradle beam. The boat lift step WILL NOT WORK on Shore Station Brand lifts or any other brand which has a horizontal bar on the side of the lift frame itself- it requires a V-cut lift frame (the outer boat lift frame itself, not the cradle, like the photos above) on the dock side to avoid interference as the step travels up and down with the cradle. Not all V-side lift frames will work either, especially if your side frame diagonals making the V meet in the middle (like the lift with the dark gray Tracker fishing boat in the pictures above) instead of closer to the corner of the lift- you may have to face the step inward or mount on the inside of the cradle to get it to clear, which will put it closer to your boat! This is simply a MOSTLY universal option- look at the pictures and make your own judgment on whether it will work and how it will be oriented on your lift, and where that will line up with your boat.
The vertical mounting tubes measure 32" tall, and has 20" of space between the angled support gussets and the bottom of the tube, so theoretically you can have 12-13" of vertical adjustability depending on the size of your lift cradle. The TITAN gray composite tread is 1'x3' and provides a grippy surface for confident loading and unloading. These are great for putting narrow boats on wide lifts as well, helping to bridge the gap to the boat without having to offset the bunks to one side of the lift.
Sorry, due to outrageous shipping fees, we will not ship the Guides or Boat Lift Steps
SUPERIOR Poly/ Aluminum 12' Horizontal Boat Guide-Ons- $536 plus 6% tax
SUPERIOR Boat Lift Step-Over (Aluminum Frame w/ Titan Composite Tread) - $277 plus 6% tax
HEAVY-DUTY ALUMINUM DOCK LADDERS
We searched long and hard for an all-aluminum dock ladder that was lightweight, strong, good looking, and affordable. We didn't find one, so we had one built. This one has the option of flipping up to keep it out of the water and lake scum when not in use, or can be bolted directly to the dock. Anodized finish on the entire ladder for a better grip and a sharp look that'll stay cool to the touch. With children running around, the soft curves of the tubes make for a safer dock environment, and more comfortable grip while using the ladder, as well as the wide 4" treads are comfortable on your feet versus most rung ladders on the market which create sharp pressure.
Easy to assemble with the provided instructions. Tread spacing is 11" down from top of dock, 11" apart thereafter, i.e. the 4 Step HD Ladder has a 44" reach from top of dock to the bottom tread.
300 lb. weight limit.
Keep in mind, your dock surface should be 16-28" above the water level, so add that extra length into your calculations when figuring out the size you need!
2021- Ladder Styles May Differ From Pictures Due to Supply Shortages!
3 STEP HD LADDER (Fixed mount without flip kit) $201.00 plus 6% tax
4 STEP HD LADDER (Fixed mount without flip kit) $221.00 plus 6% tax
4 STEP HD LADDER (Most Popular) w/ flip kit $241.00 plus 6% tax
5 STEP HD LADDER w/ flip kit $255.00 plus 6% tax
Add 3% for credit/ debit cards
A great value in a 3 or 4 step angled ladder for your dock or pontoon. The standard "J" hook with Footman's loop attachment allows for quick and easy ladder removal. Purchase the optional Add-a-Ladder location kit and use the ladder for both the dock and pontoon. No-skid steps make for a safe and comfortable ladder. Easy to assemble instructions.
225 lb. weight limit.
Aluminum Pontoon/Dock 3 Step Ladder $155.00 plus 6% tax
Aluminum Pontoon/Dock 4 Step Ladder $163.00 plus 6% tax
Add-a-Ladder Location Loop Kit $15.00 plus 6% tax
DOCK/ PIER BENCHES
SUPERIOR Dock/ Pier/ Patio Benches- Titan Gray Composite Decking
Our own line of dock benches- SUPERIOR is made to last and look good while doing it! Lightweight, clean looking, and will last outlast your boat! Perfect for your dock/ pier platform, or even your lakeside patio for a low maintenance system that stays cool and comfortable. Requires drilling 4 holes in your dock for secure mounting, then easy on/off anually with just 4 bolts holding it in place. Could be easily lag-bolted into some buried 6"x6" treated wood for an easy and stable beach mount too!
SUPERIOR 4' Titan Gray Composite Dock Bench- $275.00 plus tax
WAVE ARMOR COMPOSITE BENCH
4' Sandstone-Tan Poly Dock Or Patio Bench
WAVE ARMOR Brand 4' Wide Sandstone-Tan Poly Dock or Patio Bench, perfect for your dock platform or lakeside patio deck to give you a place to relax and have the best view of the lake.
Features molded cupholders in the armrests and comfortably fits 2-3 adults. 52" wide by 37" tall by 27" deep, includes bolts.
WAVE ARMOR 51" Sandstone-Tan Poly Dock Bench- $469.00 plus tax
***All prices, available inventory, and product lines are subject to change without notice!***
Lifts Ladders And Docks.Com:
A Division of BlueScape, Inc.
For Quotes or Service:
Text or Call:
Click below for a quick quote:
Sales and Service
Text or Call:
Click below for a quick quote:
Northern Michigan Rep
(For Customers North of Big Rapids ONLY)-
(No Inventory- Schoolcraft Is Our Only Location)
For Customers North of Big Rapids Only-Call
WAREHOUSE AND SHOWROOM
11811 S. Shaver Road
Schoolcraft, Michigan 49087
Just South of Kalamazoo, MI
Boating Season Hours:
Tuesday-Friday 12:00 pm - 5:30 pm
Saturday 10 am - 1 pm
Sunday & Monday- CLOSED
We're Available Most Business Days In The Mornings By Appointment- Just Text Ahead For Availability
Cash or Checks
All Major Credit or Debit Cards with 3% Fee Added To Total Bill